Page 3 of 17
.
WARNING CAUTION
NEVER
use a wall mount bracket from another manufacturer.
This product is
not intended
to be a
primary heat source
. It is for
supplemental heat only.
INDOOR use only! NEVER
use this heater
outdoors!
Doing so may result in
electric shock!
Risk of electric shock
!
DO NOT OPEN!
No user-serviceable parts inside!
ALWAYS
turn this heater off before unplugging it from the outlet.
ALWAYS disconnect
this unit from the
power
supply
before
performing any assembly or
cleaning, or before relocating the electric fireplace.
NEVER
leave this heater unattended.
ALWAYS
unplug this heater when not in use.
ALWAYS
store this heater in a dry location.
NEVER
use the fireplace if it has become wet.
NEVER
plug this heater into an outlet that is
old
,
cracked
, or has any
loose wires or
connections
. Plugging this heater into a faulty outlet could result in
electric arcing
within
the outlet that could cause the
outlet
to
overheat or catch fire
.
ALWAYS
check your heater cord and plug connections with
each use
!
i)
MAKE SURE
the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can cause the outlet to overheat.
ii)
Heaters draw more current
than small appliances.
Overheating
may occur even if it
has not occurred with the use of other appliances.
iii) During use
check frequently
to see if the
plug outlet or face plate
is
HOT
!
iv) If the outlet or face plate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.
The power cord supplied with the heater
has a plug with two flat blades (live and
neutral) and one round pin (ground). If a 3-
slot receptacle is not available, an adapter
MUST
be used. The adapter
MUST
be
properly grounded
to the outlet box (see
figure
at
right).(Note:Adapter
NOT
INCLUDED.)
SAVE THESE INSTRUCTIONS!
PREPARATION
This product includes a
GLASS panel!
Always use
extreme caution
when handing
glass.
Failure to do so could result in
personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grounded for wall-hanging or recessing use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever
possible.
You w
i
ll need the follow
i
ng tools
(not included): Phillips screwdriver; stud finder; level;
tape measure; electric drill; 1/4” wood drill bit, hammer.
