The uncut Depron parts
as you will receive
them.
Begin by carefully cut-
ting all the tabs.
All the parts once cut
out.
The edges may be
burred.
Using 400 grit sand pa-
per give all the edges a
light sanding.
The fuselage section
parts shown here.
Look carefully at this
4 rows of parts. These
parts will be doubled
up.
(
Notice the direction of
the taper on the center
sections on the first 2
rows
.)
Double up the parts
and glue them together
as shown. Keep them
centered leaving 3mm
on each left and right
side. The 3 sections
of parts is the bottom
fuselage.
The kit will include 2
wing halves that are
pre-curved. These will
be the top skins of the
wing.
The carbon fiber parts
and hardware as in-
cluded.
Using a marker as
a rolling pin, roll the
bottom parts to form
a similar shape as the
bottom of the fuselage.
Use 2 hands and roll
it as if you’re rolling
dough, and it will curve
up.
