Nanni N13.430 CR2, Руководство оператора

Страница: 63 / 110

63
S08 MAINTENANCE
DRAINING THE ENGINE OIL
OIL DRAINING:
1. Start the engine and let it warm few minutes to
render oil more fluid to ease suction.
2. Stop the engine and remove the key from the panel.
3. Remove the oil cap.
4. Open the tap at bottom of pan and pump used oil.
5. Close the tap.
6.
Refill with oil.
Oil drain tap.
Conveniently placed oil caps.
CHANGING THE OIL FILTER
Replace the oil filter every time the engine oil is drained.
1. Remove the oil filter casing with a filter wrench tool.
Turn it counter-clockwise (CCW). Remove the gasket.
2. Apply clean engine oil to the new filter at the inner
and outer seals and to filter threads.
3. Wipe both sealing surfaces of the header with a
clean cloth. Ensure that the notches in dust seal) are
properly installed in the slots of the housing. Replace
4. Install and tighten oil filter by hand until firmly against
dust seal. DO NOT apply an extra 3/4 to 1-1/4 turn
after gasket contact as done with standard filters.
Tighten drain plug to specifications :
5. Start the engine and let it operate few minutes at idle.
Check if the oil pressure warning lamp turns off.
6. Stop the engine, wait for the engine to cool down and
check the oil level. Top up if necessary.