Nanni N13.430 CR2, Руководство оператора

Страница: 55 / 110

55
MAINTENANCE
PÉRIODICITÉ
Daily
1
st
Maintenance
100 hours (
1
)
Every
250 hours or
1 year (
1
)
Every
500 hours or
2 years (
1
)
Every
2000 hours or
2 years (
1
)
COMPONENTS
FUEL CIRCUIT
Water in fuel - Pre-filter / Filter Draining
Fuel Filter (
2
)
Fuel injectors - Check Cut out and misfiring with Diagnostic Tool (
4
)
Mechanical Fuel injectors (
5
)
LUBRICATION CIRCUIT
Engine oil level (
2
)
Engine Oil (
2
)
Oil Filter (
2
)
Crankcase Ventilation Filter (C.C.V.)
COOLING CIRCUIT
Coolant level (
2
)
Coolant Concentration control (
2
)
Coolant Liquid (
2
)
6000 hours or 4 years (
1
)
Thermostat Inspection (
2
)
Calibrated Heat-Exchanger Cap (
2
)
Heat-exchanger - O-Rings
Inter-cooler - O-Rings
RAW WATER CIRCUIT
Raw Water Filter. (
2
)
Raw Water Pump Impeller. (
2
)
Raw water pump Overhaul.
Anodes Check and Replacement.
(
2
)
AIR INTAKE & EXHAUST CIRCUIT
Turbo-charger Inspection
Air Intake Filter
(
2
)
Exhaust Mixer Inspection (
2
)
ELECTRICITY / ELECTRONIC
Battery electrolyte level
Electrical Harness Connectors Inspection
Alternator Belt
(
2
)
Panel Command : Indicators & Warning Lamps
Read out the Defect Trouble Codes (
6
)
WHOLE ENGINE
Engine Mounts Inspection.
4 years
Engine Alignment
When Mount Replacement
Hoses / Clamps tightness / Bolts / Nuts Tightening
Visual Inspection (Coolant, fuel, oil, exhaust & raw water leaks)
Valve Clearance
Check Crankshaft Vibration Damper
(
7
)
TRANSMISSION
Transmission Oil level (
3
)
Transmission Oil and Filter (
3
)
Transmission Oil Cooler (if equipped)
(
1
) Whichever come first (at the first occurrence)
(
2
) Operations to be performed in accordance with user and maintenance manual for your engine. For all technical information specific to your engine, refer to the user and maintenance
manual.
(
3
) Operation to be perform in according with the transmission manufacturer user and maintenance manual.
(
4
) Mechanical injection engines N5.150 - N5.140E - N6.160 - N6.180 - N6.200 - N6.230 - N6.240E - N6.270E - N6.300E are not concerned.
(
5
) Only mechanical injection engines N5.150 - N5.140E - N6.160 - N6.180 - N6.200 - N6.230 - N6.240E - N6.270E - N6.300E are concerned.
(
6
) Only engines N5.150 - N6.160 - N6.180 - N6.200 - N6.230 are not concerned.
(
7
) For N5 and N6 check if the engine is equipped. The crankshaft vibration damper must be replaced after 4500 hours or 5 years whichever come first (at the first occurrence)
CHECK/ADJUST/CLEAN/SERVICE/REPLACEMENT IF NECESSARY REPLACE
S08 MAINTENANCE