11
·
The connection between the light fixture and DMX512 console, light fixture and light fixture should use five core shielded cable and make sure its diameter is not
less than 0.3mm. XLR plug/socket and the wire should be connected as the picture aboved.
·
Pin1, Pin2, Pin3 for connecting DMX singal, Pin4, Pin5 is connectionless.
▲
Note: When connect with socket, make sure the internal pin not be in contact with the inner case.The fixture can match the the DMX512 (1990) control signal.
·
Plug of five-core and three-core XLR plug/socket conversion.
The fixture comes with five-core XLR plug. lf you use the three-core XLR plug, kindly follow below instruction.
②
DMX-in Port
ln DMX mode, make sure the last light is the only light with a cable connected to DMX output. There is a resistance about 120(OHM) between the second pin and
third pin of this plug (as shown).
Make sure this plug can be installed into the output of the last fixture, this will help avoid noise and reflection phenomenon caused by the DMX512 signal during
the transmitting process.
③
Set the address of the fixture.
④
Refer to the attached DMX reference guide and control the light via DMX512 console.
(For specific operation methods, please refer to the DMX512 console operation manual.)
Note: DMX Reference Guide
《
TK-140B/TK-280B DMX Reference Guide (NANLUX)
》
please download from www.nanlux.com
Three Pin
Pin 1: GND(SCREEN)
Pin 2: Signal(-)
Pin 3: )
Five Pin
Pin 1: GND(SCREEN)
Pin 2: Signal(-)
Pin 3: )
Pin 4: N/C
Pin 5: N/C
DMX circuit connection connect
a 120(OHM) resistance between
the 2pin and 3pin of theXLR plug
and then connect it to the DMX
output socket of the last fixture.
PIN 2 PIN 3
120Ω
1
3
2
