clockwise. Be careful so that the parts threading properly
against each other.
3.2 CHANGING THE LENS
●
Open the dive light by unscrewing the sealing plastic plug
counterclockwise. Note that after having unscrewed the
plug, the negative pressure in the lamp head may require
some force to pull the parts apart.
●
Remove the lens manually by gently wiggling it.
●
Insert the new lens, being careful so that its legs are aligned
correctly in the lamp base.
●
Close the dive light by pushing the plastic plug into the pipe,
past the first o-ring. Tighten the plastic cap by turning
clockwise. Be careful so that the parts threading correctly to
each other.
3.3 USAGE
The drop-shaped knob controls the functionality of the lamp.
Loosening or tightening the screw can adjust wrath of inertia.
3.4 SWITCH THE LIGHT ON
●
Turn the knob clockwise. It will start at 75 %.
●
To check the battery charge status: turn the light on and
then off within 2 seconds, a number of short flashes indicate
battery charge status:
Flashes
Battery Level
4
75-100%
3
50-75%
2
25-50%
1
5-25%
When the battery levels falls, the amount of light will
automatically be reduced to save the battery, and allow the
user to end the dive safely.
3.5 SWITCH THE LIGHT OFF
●
Turn the knob counterclockwise until it touches the locking
position, the light will go off with a delay of 2 seconds.
●
Turn the knob counterclockwise past the locking position, to
ensure that the light does not come by accident, for
example during transport.
3.6 DIM THE LIGHT
●
Turn the knob counterclockwise until it touches the locking
position, and back again within 2 seconds. It will switch to
full effect.
●
Repeat the maneuver for further dimming.
●
In this way, the light is dimmed gradually in three steps.
