User Manual
Nanight Sport 2 Dive light
Thank you for choosing a dive light from Nanight! The lamp is
designed for diving at depths of up to 200m. We at Nanight hope
your new lamp will give you many rewarding days and nights of
diving!
1
PRODUCT DESCRIPTION
●
Output: 4000 emitter lumens
●
LED Type: Cree XHP35
●
Battery: 14,4V Panasonic Li-Ion, 3350 mAh
●
Burntime: 2:11 h - 5:22 h(
see graph page 2
)
●
4-step dimming
●
Operating temperature: 0 – 35°C
●
Operating voltage: 5 - 20V
2
NANIGHT
SPORT
INCLUDES
THE
FOLLOWING
PARTS
●
Dive Light
●
Charger
●
Lenses 10 and 35° (ca 120° without the lens)
●
Battery pack
●
Case and a sticker
3
BEFORE USE
3.1 CHARGE THE BATTERY
●
Open the dive light by unscrewing the sealing plastic plug
counterclockwise.
●
Disconnect the battery connector by pressing down on the
latch and pull the connectors apart (see picture).
●
Connect the charger connector to the battery connector.
It
is important that the connectors are connected to each
other in the correct orientation
(see picture).
●
Plug the charger into a wall outlet. The charger's indicator
light turns from red to green when the battery is fully
charged.
●
When the battery is fully charged, disconnect the charger
connector and reconnect the dive light connector.
It is
important that the connectors are connected to each other
in the correct orientation
(see picture).
●
Inspect the o-rings, clean any debris and replace them
immediately if damage exists.
●
Make sure that the elastics around the battery is tight and
keeps cords and plugs in place.
●
Close the dive light by pushing the plastic plug into the pipe,
past the first o-ring. Tighten the plastic cap by turning
