56
behind each channel if the function is selected. When the
scan function is set to be ON, the channel can be scanned
automatically in standby state, and you can talk on this
channel while there’s signal. Rotate the channel selector
to channel 16 to activate the scan function, and then those
channels which set automatic scan will be activated by itself.
For instance, if the scan function of channel 3,5,7 was
activated by PC software programming, when you rotate the
channel selector to channel 16, the transceiver will scan
channel 3,5,7,16, when receive signal from one of these four
channels, it will stop scanning, and talk on this channel. It’s
normal that it will be delayed when you open the speaker after
activating the scan function, the delay time is related to the
number of channels which set scan function.
Note: You can also set priority channel, even if the transceiver
stay in the Non-Priority channel, it still keep spying the priority
channel. Once receiving some signal, it will turn to the priority
channel immediately
Busy Channel Lockout
1. Open the PC software to choose the channel you require.
NF-668 can be set to be OFF, carrier wave busy lockout
and CTCSS busy lockout. Only the
channel was set CTCSS or DCS, can it open CTCSS/DCS
busy lockout.
Function Setting
