RF30
© 2010 All rights reserved Printed in China
http://www.namsung.com
Installation
Installing the RF30 Receiver
1.
Connect the 3.5mm cable to the REMOTE IN input on the back of the radio. ex)
WM3000RF
2.
Connect the black wire from the RF30 receiver to a good ground (-) source.
Typically, the ground wire connection from the radio wiring harness can be used.
3.
Connect the red wire from the RF30 receiver to a 12 volt accessory switched
power source. This may be connected to the red accessory power wire at the
radio wiring harness.
See illustration below for connection details.
Inserting the battery in the RF30 remote
Insert the battery (CR2025) into the RF30 remote control with the (-) negative battery
terminal facing in toward the RF remote, and the (+) positive battery terminal facing
outward toward the battery cover. See illustration below.
