JUMPIN’ JACKPOT
™
Operator’s
Manual
4.0 INSTALLATION
Note: Shipping damage may void the warranty. In case of shipping damage, contact your
distributor and the transportation carrier immediately.
1. Unpack the game.
2.
Position the game close to its final spot. Leave enough room for access to the back
side.
3.
Unscrew the (7) screws holding on the back panel, then carefully pull the top of the
panel outward and then lift to remove it.
4.
Place the platform on the floor with its two pipes pointing towards the front of the
game.
5.
Remove the (2) cotter pins from the ends of the pipes. Make sure the wire harnesses
stay below the opening of the pipes. (
-CAUTION-
wires can be severed if this step is
not followed.)
6.
As one person tilts the game cabinet backwards (
-CAUTION-
do not exceed 20
degrees of tilt.) another person needs to slide the platforms pipe section under the
game. When the pipe ends are close to their mating holes on the under side of the
game cabinet you can tilt the game back down.
7.
Use your hands from the underside of the game cabinet to maneuver the pipes until
they come up through the holes. Pull the wire harnesses out of the pipes. Carefully
insert the (2) cotter pins back into the pipes avoiding the wires. Connect the (2)
harnesses to their mating connectors.
8.
Reinstall the back panel using the (7) screws. Move the cabinet into its final position
while lifting the platform just off the ground. This will make it easier for the game to
move. When in position adjust the (4) leg levelers on the platform if necessary.
3
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200