Antenna connector - GSM/GPRS
For connecting antennas for GSM/GPRS there is a
connector of type SMA on the circuit board of the
REGGAE mini GT communicator Any antenna that
satisfies the necessary operation conditions in the range
GSM/GPRS 900/1800 MHz with impedance 50 Ω can be
used
Antennas can be adapted for both indoor and outdoor
usage
On the REGGAE mini GTbz communicator it is most
common to use a thin rod antenna screwed directly on
the SMA connector
Telephone part of communicator
The telephone part of the circuit board of the
REGGAE mini GT communicator is able to communicate
with the ESS panel in all common pulsation and DTMF
formats Supported formats are 4+2, Ademco Point ID
(Contact ID), communication speed 10, 20 or 40 bps
with handshake 1400 Hz, 2300 Hz or multi-tone
Dialled telephone numbers can be set up as pulsation or
DTMF at the ESS panel
The terminal plates marked „T1“ and „R1“ are used for
connecting telephone lines from the ESS panel
For powering telephone lines, the REGGAE mini commu-
nicator creates voltage of approximately 24 V and this is
on the terminal plate T1 / R1 in cases where the ESS panel
does not answer the telephone
The telephone part of the REGGAE GT communicator can
generate the dialling tone of the line for the ESS panel
This function is optional in the communicator configu-
ration
The circuit board of the REGGAE mini GT is not capable of
GSM portal function
Acoustic output
On the circuit board of the communicator there is an
acoustic output for monitoring the telephone lines of the
communicator Turning on the monitor is carried out by
the NAM manager software through configuration and
diagnostics
U
S
E
R
M
A
N
U
A
L
www.namsystem.com
REGGAE mini GT/GTbz
Communicator for GPRS transmission
9
