Nakayama SP1040, Быстрый старт

Страница: 9 / 12

6
OPERATION
Connecting pressure pipe
- screw the pressure pipe onto the pressure connector. All joint
connections must be sealed with a threaded sealing stripe.
-When using the hose, screw the right hose adapter into the
pressure connector.
-Secure the hose firmly to the hose adapter and secure it with a
hose clamp.
If it is used occasionally, please use a suitable pipe. A rigid pipe
with a check valve is recommended for use in a fixed position.
This can be done at the close of the machine to prevent liquid
backflow.
Use a strong rope to connect the handle of the pump and dip it
into the liquid to be conveyed at a certain angle, so that the
lower side of the device has no bubble formation to prevent the
bubbles from being sucked in. Put the equipment down slowly,
and once the pump is submerged, it can be adjusted again. The
pump is arranged at the bottom of a liquid container, Fasten the
end of the rope after lowering so that the pump can also be
handled when hanging on the rope. The pump can work after
the device is connected to the main power source.
The pump is not allowed to transport corrosive
substances, flammable and explosive substances
(such as gasoline, petroleum, nitro diluent), grease,
oil, brine and toilet equipment sewage, as well as
low mobility mud sewage. The temperature of the
liquid cannot exceed 35
°C
.