Nakayama SP1040, Быстрый старт

Страница: 7 / 12

4
INSTALLATION AND COMMISSIONING
Long enough and strong ropes should be attached to thehandle
before the first use. When the pump is immersed into the liquid,
the rope along with a handle can be used to balance the pump.
Installation
The equipment requires an area of at least 60x60cm.
Depth of equipment immersed in technical parameters.
When installing the equipment, make sure the open will not the
suction opening will not be blocked by foreign objects to keep
the equipment stable.
Set toggle switch
1.A change-over switch is a device that can be steplesslyadjust-
ed. For this, you first need to loosen the screws. The position
control height of the switch water can be set by stepless adjust-
ing the length of the power line.
2.Please check the following items before the pump startsrun-
ning:
3.A float switch must be installed so that it is easy to switchbe-
tween the ON and OFF switching points. This should be
checked, and the floating switch should be carefully picked up
and put down again. When you do this, pay attention to the
switching status of the switch.
4.Ensure the distance between the top of the floating switch
and switch line card buckle is not too small. If the distance is
too small, it cannot guarantee normal work.
5.When you set up the float switch, make sure that the switch
does not touch the base before the pump is opened. Warning:
There is a risk of dry running.
6.Set the switch to automatically control the height of the water
level by adjusting the position of the float switch cable at the
card line.
7.Please check the following items before the pump startsrun-
ning: