Nakayama Premium Series, Руководство пользователя

Страница: 25 / 40

5
WWW
.N
AKAYAMA
T
OOLS
.
COM
engine oil into the air cleaner.
②
Select the appropriate lubricant for the diesel engine according to the
environmental temperature. (See figure 9)
4. Refill 0# or -10# or -20# light diesel into the diesel engine.(See the instruction manual
of the diesel engine for details)
Note: do not exceed the mark when refilling.
5. Make pre-starting preparations according to the instruction manual.
Ⅳ
. Starting
( Note: the shift bar must be on the neutral position)
1. Start the diesel engine according to the procedures stipulated in the instruction
manual for the diesel engine.
2. The diesel engine should run at a low speed (1500-2000 rpm) under no load for 2-
3 minutes.
3.
Check whether the diesel engine runs normally or not. If it is abnormal, stop the
engine and have a check.
Ⅴ. Operation (Note: breaking-in must be performed before the use of power tiller, see
the breaking-in method in chapter Four)
Entrance of lubricant:
Fill in machine oil from oil month when diesel engine
is placed level, and checking the oil level only needs
a poke by dipstick rather than a rotation of dipstick
Classification of
maintenance for
A. P.I.
diesel engine
Lubricant shall be grade CC or CD
Model 178F 186F 188F
Litre(British gallon) 1.1(0.24) 1.65(0.36) 1.65(0.36)
1. Using a slow shift
①
The left hand grasps the clutch handle tightly and makes the clutch separated.
②
The right hand pulls the shift bar backwards, make sure the shift casing locates in
the slow shift position, and observe whether it reaches the right position or not.
Then the right hand grasps the right handle.(Note: do not grasp the reversing bar)
③
Loosen the clutch handle gradually, the clutch will combine, and the power tiller
can run at a slow speed.
④
The right hand increase the throttle properly, the motor can run at a speed of 5 km/h
2.
Using a fast shift
①
The left hand grasps the clutch handle tightly and makes the clutch separated.
②
The right hand pushes the shift bar forwards, make sure the shift casing locates in