Nakayama MB9005, Руководство пользователя

Страница: 27 / 41

7
WWW
.N
AKAYAMA
T
OOLS
.
COM
④
Fasten upon the handle bar(Grasp the emergency stop handle and the handle bar
with your left hand), and buckle the trigger of emergency stop lock come out from
the clutch handle gently by your middle finger, the clutch handle restoration adown,
then the clutch switch on, and the machine start to work. You should grasp the
emergency stop handle and handle bar all the while in whole working course.
⑤
Meet emergency, release the emergency stop handle and handle bar, the engine will
flameout and the machine will stop working immediately.
7.
Stop the machine
①
Grasp the clutch handle, and make the clutch separated.
②
Pull the shift bar to the neutral position, loosen the clutch handle, switch the oil
switch clockwise to the minimum position, the machine will stop.
③
When stopping the diesel engine is needed, the stopping should be conducted
according to relative contents in the instruction manual. (Note: stopping the
machine is generally conducted on the flat ground)
Ⅵ
. Connection use of Auxiliary Devices & Tools
1. When cultivating is needed, knock down the wheels, fix the hexagonal union of the
cultivating device onto two ends of the hexagonal shaft of the running part, and
axially fix them with M8×55 bolt. Note: cultivating blades are divided into two
groups, namely, the left and the right. Fixing the blades should guarantee that when
the machine is running, the blade edge should work first. After fixing the blades,
also fix the left and right protection board for safety purpose. Depth of the
cultivating can be realized by adjusting height of the velocity adjustment screw and
angles between the lever and the ground ( refer to table 4).
2. Cultivating for paddy field: when the submerged depth of human’s feet in the paddy
field is less than 25cm, bent blades for wet land can be directly used for the
cultivating of paddy field.
Deep Furrowing Resistance Stick
3. When ditching is needed, unlade the Deep Furrowing Resistance Stick, fix the
ditcher, adjust width & height of the ditcher, then ditching can be conducted.( See
Figure 3)