Nakayama EB1410, Руководство пользователя

Страница: 10 / 23

10
WWW
.N
AKAYAMA
T
OOLS
.
COM
When the end of the wire is less than 2.5 cm:
• Switch off the appliance and disconnect it
• press the coil to lock it and pull the remaining wire strongly
• too short wires do not have enough centrifugal force to lengthen automatically
If you do not see the end of the thread:
• Replace the cutting head (see chapter Maintenance and cleaning).
Cutting instructions
• Always wear appropriate harness and protective clothing during use.
• When starting or working, make sure that the cutting head does not touch any stone, gravel, wire or other foreign matter.
• During use, avoid too much effort on the equipment.
• Avoid contact with fixed objects (rock, wall, fence, batten, etc.). Use the crankcase edge to maintain the correct distance.
• Do not run over the cable with the machine running. This can cause damage. The cable must remain on the back of the
user.
• Start the unit before approaching the lawn.
• Begin mowing from the electrical connection, do not approach the cutting head of the electric wire and work away from it.
• Cut the tall grass in several stages from top to bottom.
• Do not cut damp or wet grass.
Working with the cutting head
• Short or worn wires cut badly. If there is an inefficient cut, check if there is any wire remaining in the coil. Read the
paragraph Wire extension.
• During use, hold the cutting head just above the floor at all times and gently rotate the unit. Cut gently and keep the
machine tilted about 30 ° forward.
Working with the metal blade
Make sure the blade is properly mounted. Replace damaged or blunt blades. There is a risk of injury!
• Blades cut only free surfaces. Inspect the area thoroughly and remove any foreign matter. Avoid impacts with stones, metal
or other obstacles. The blades could be damaged and there is a risk of retro-shock.
• Inspect the damaged blades regularly and replace if necessary.
• Do not use the appliance to cut rejects or thickets.
• During use, hold the head above the floor and rotate the appliance like a regular left and right arc.
• Do not hold the cutting head tilted.
Maintenance and storage
Before working on the appliance, unplug it.
If work is not described in this manual, it must be done by the authorized service. Use original parts and be careful when
installing the cutting blade. There is a risk of injury!
Never use worn or non-original parts. Use only genuine parts. Never use metal wires. Use of non-original parts may result in
adverse health effects and irreparable damage to the unit and immediately voids the warranty.
Maintenance of angle return
Before each use, check and add, if necessary, the grease for the angle drive (Fig 8A).
Remove the screw on the side of the return housing. Lubricant Castrol LMX.
Replacing the cutting head (figure 9)
1. Disconnect the power supply.
2. Turn the appliance upwards to raise the head.
3. The coil housing and the coil are inserted only. To open, remove the cover (A) from the cover (C). Remove the coil (B).
4. The coil is supported by a spring, on either side of the spring there is a washer (top and bottom).
5. To reload coil D with wire, pull the wires through the eyelets (E) of the housing. Hold the wires in the eyelets (E) of the reel
housing. Push the reel into the housing. Pull the two wires. Check that the resorts are properly installed. Replace the spool
cover.
6. Press and hold the knob (D) and pull the thread sufficiently past the automatic thread cutter.