15
16
POWER CORD CONNECTION
WARNING
Only use grounded power sources. Failure to properly ground the unit may result
in electric shock, injury, fire and/or damage to the system components.
(1) Insert the female plug into the main power inlet box
[
10
]
on the front of the unit.
(2) A screw hole is provided on the lower, right side of the control unit for attaching the
tension relief. Use the provided Nylon Tension Relief to attach the power cord to the side
of the control unit.
Fig. 15
MOTOR CORD CONNECTION
(1) Align the guide pin A on the motor plug with the key way B on the motor socket on the
front of the control unit.
(2) Screw in the coupling nut C of the motor plug to the motor socket D on the front of the
control unit.
Fig. 17
Fig. 16
A
B
D
C
8-3 Rubber Pad Installation
When placing the control unit horizontally, the Rubber Pad (Provided) is installed at the side
of the air vents. Install the control unit so the air vents are underneath the control unit.
When installing horizontally, remove the 4 screws on the Control Panel and remount the
panel at a 90° Angle.
Before removing the control panel be sure the Power Switch is OFF and remove the Power
Inlet Cord.
8-4 Proper Clearance
When installing 2 or more control units in the machine cabinet make sure to check that each
single control unit has the proper clearance on all sides.
Fig. 11
Fig. 12
Fig. 13
Vertical mounting
Horizontal mounting
min.30mm
min.20mm
min.30mm
min.30mm
Rubber Pad
Control Panel
Screw
CAUTION
Never install the air vents upward when installing the control unit horizontally.
This may cause damage to control unit.
[
10
]
CAUTION
Before connecting the motor cord, make sure the power source is switched off.
Nylon Tension Relief
9
10
Fig. 14
min.30mm
min.20mm
min.30mm
min.30mm
E3000C̲K0446E̲e̲080108 08.1.8 6:34 PM ページ15
