1
OPERATION MANUAL
AM-2526
・
AM-H2526
Air Motor
OM-K0428E 001
Thank you for purchasing the Air Motor AM-
2526
•
AM-H
2526. The Spindle and Air Line Kit are required to
drive these motor.
Read this Motor, Spindle and Air Line Kit Operation Manuals carefully before use.
1
.
CAUTIONS FOR HANDLING AND OPERATION
■
Read these warnings and cautions carefully and only use in the manner intended.
■
These warnings and cautions are intended to avoid potential hazards that could result in personal injury or
damage to the device. These are classied as follows in accordance with the seriousness of the risk.
WARNING
①
The motor is not a hand tool. It is designed to be used on CNC machines or special purpose
machines.
②
Do not touch the cutting tool while it is running. It is very dangerous.
③
Wear safety glasses, dust mask, and use a protective cover around the motor whenever the motor
is rotating.
④
Never operate or handle the motor until you have thoroughly read the owner's manual and safe
operation has been conrmed.
(1) To prevent injuries / damages, check the motor for proper installation, before operating the
motor.
(2) Before disconnecting the motor, always turn the control power off and turn the compressed air
off. Then it is safe to remove the motor.
CAUTION
①
Do not drop or hit the motor, as shock can damage to the internal components.
②
When cleaning a motor, stop the motor and remove debris with a soft brush or a cloth. Do not blow
air into the motor with compressed air as foreign particles or cutting debris may get into the ball
bearing.
③
Stop working immediately when abnormal rotation or unusual vibrations are observed. If vibrations
occur, please check the content of section 7 " TROUBLESHOOTING ".
④
After installation, repair, initial operation, or long periods of non operation, please carry out break-
in as follow. Start rotating slowly and over a short period of time, increase speed gradually until
allowable maximum speed.
⑤
Do not disassemble, modify or attempt to repair the motor. Additional damage will occur to the
internal components. Service must be performed by NSK NAKANISHI or an authorized service
center.
Class
Degree of Risk
WARNING
A safety hazard could result in bodily injury or damage to the device if the
safety instructions are not properly followed.
CAUTION
A hazard that could result in light or moderate bodily injury or damage to the
device if the safety instructions are not followed.
