SOFTWARE INTRODUCTION
D. Output channel adjustment area
7 EN
* Restore Equalizations button: Switch between the currently designed equalizer state
parameters and the pass-through mode (the gain of all equalization points is restored to
0dB, the frequency and value are unchanged).
*"GEQ" button: click to select graphic equalization or parametric equalization
.
* "Delay Unit" button: Select the delay unit by clicking the left or right arrow, available
in milliseconds, centimeters, and inches.
Output channel adjustment aream, positive and negative phase of each channel,
volume adjustment, mute, joint adjustment, etc.
E. Main volume adjust zone
Adjustment Range: ON/OFF, -59dB~6dB.
Click the speaker button to mute the main volume.
* Sound adjustment: slid the scroll up and down to adjust the sound level of the
channel, or input the value or scroll the mouse wheel in the sound input box to adjust
the sound size. Click the horn button to switch between mute.
* Positive phase adjustment: Click [0°] or [180°] to switch between positive phase and
reverse phase.
* Delay: set the delay value by scrolling the mouse wheel in the delay input box, or
enter the value to set the delay value.
* Reset output configuration: Customizable for channel type.
* Lock output type: Locking for the current output channel type is not customizable.
* Output left and right joint adjustment: The joint of the left and right channel data of
the output channel can be copied from left to right, or from right to left.
C. Channel divider editing area
Main function Setup: Channel High & Low Pass Filter
Setup.
Adjustable: Filter Type, Frequency point and Q Value
(Gradient or Slope). When the slope is 6dB/Oct, the
type is NULL.
