e23
NAIT XS Integrated Amplifier
note:
The AV Bypass feature must be used with care. It
bypasses the NAIT XS volume control leaving any signal
connected to the av input to be passed to the speakers at
full volume.
note:
The mute function is disabled when AV Bypass is
engaged.
22.6 auxiliary Inputs and outputs
The NAIT XS incorporates
pre-amp out
and
power-amp in
sockets on its rear panel. In normal use these sockets are
connected by a link plug. The link plug should be removed
only in the following circumstances:
• A power supply upgrade is to be used.
• An alternative preamplifier is to use the NAIT XS power
amplifier section.
• An alternative power amplifier is to use the NAIT XS
preamplifier section.
Diagrams 23.3 and 23.4 illustrate use of these sockets.
When an external preamplifier is connected to the NAIT XS
power-amp in
socket, a fault will initially be indicated by
the
mute
button flashing. To clear the fault, press and hold
the flashing
mute
button. This will un-mute the amplifier and
turn off the display and volume indicator.
The NAIT XS provides an unfiltered analogue stereo
subwoofer
output via a pair of RCA phono sockets.
note:
The subwoofer output is a duplicate of the
preamplifier output. No low-pass filtering is applied.
22.7 Power supply upgrades
The NAIT XS preamplifier section can be upgraded through
the connection of an external Flatcap, Hi-Cap or Supercap
power supply. Diagrams illustrating power supply upgrades
are shown in Section 23. The NAIT XS and external power
supply must be switched off when connections are made.
Switch on the external power supply first followed by the
NAIT XS when all connections are complete.
22.8 General Connections notes
The NAIT XS negative input and output connections for
each channel are common. The mains earth (ground)
should always be connected regardless of what other
equipment is used in conjunction with the amplifier. The
mains earth only grounds the case and the electrostatic
screen within the transformer, and is not connected to the
signal negative. In order to avoid hum loops, the signal
negative of the whole system should be connected to the
mains earth (ground) in one place.
A signal ground connection is fitted to the NAIT XS rear
panel. This is intended to be used to connect a turntable
pick-up arm signal earth only.
23 naIT Xs Controls and Connections
23.1 naIT Xs Front
volume
mute
source selection
aux 1 input socket
