Naicon NAUTILUS 10-520, Руководство пользователя

Страница: 45 / 54

NAUTILUS 10●520
Three phase in/out
Rev.00
– 09 Luglio 2015
45
UPS
– messages Display
Events:
N° DISPLAY MESSAGE DESCRIPTION
1 Initializing The DSP and MCU are in Initializing.
2 Standby
3 Non Output
UPS doesn’t supply the load
4 On Bypass
Inverter output is turned off and the load connected at the
inverter output receives power from utility line via STS.
5 On Line Inverter output power is the primary energy source to load
6 EPO Activated Emergency Power Off Switch has been activated.
7 Automatic Self Test The UPS has started pre-programmed battery test.
8 Inverter in soft starting The inverter is in soft-starting
9 System Fault Detected The system has detected an internal error
10 MBS status status of maintenance bypass
11 EPO status status of EPO (emergency power off)
12 Int. Input Switch closed The internal input breaker is closed manually.
13 Int. Input Switch opened The internal input breaker is opened manually.
14 Rectifier Deactivated The rectifier has been deactivated.
15 Rectifier Activated The rectifier has been activated.
16 Rectifier Current Limit
When the input voltage is at 208V~305V, the output of the
UPS will not be interrupted, but it will be at current limit, for
example, to reduce charge current. When the load
connected exceeds its limit, the warming shall occur.
17 Battery charge deactivated The charger has been deactivated.
18
Positive Battery Boost
Charging
The Positive battery is in boost charge, which is Constant
voltage boost charge mode or constant current boost
charge mode.
19
Positive Battery Float
Charging
The Positive battery is in float charge.
20
Negative Battery Boost
Charging
The Negative battery is in boost charge.
21
Negative Battery Float
Charging
The Negative battery is in float charge.
22 Int. bypass Switch Opened The internal bypass breaker is opened manually
23 Int. bypass Switch Closed The internal bypass breaker is closed manually
24
Int. output Switch Opened
The internal output breaker is opened manually
25 Int. output Switch Closed The internal output breaker is closed manually
26 Ext. bypass Switch Opened The external bypass breaker(parallel system) is opened
27 Ext. bypass Switch Closed The external bypass breaker(parallel system) is closed
28 Ext. output Switch Opened The external output breaker(parallel system) is opened
29 Ext. output Switch Closed The external output breaker(parallel system) is closed
30 Coming to Interval transfer
Allows transfer to bypass or inverter with 3/4 cycle break.
Use of this command will drop load.
31
Coming to over load due to
inverter off When the inverter is turned off manually, the load will
exceed the power capacity.
32
Coming to Interval transfer
due to inverter off When the inverter is turned off manually, the load will
exceed the power capacity.
33
Inverter invalid due to over
load The load exceeds the capability of the single or parallel
modules.
34 Inverter Master
It indicates the Master Inverter.
35 Transfer Times-out
Latched load transfer to bypass as a result of too many
successive transfers within the current hour. Automatic
reset attempt within the next hour.
36
UPS In shutdown Due To
Overload.
The load exceeded the power capacity. The UPS has
been shutdown