Naicon MULTISTATION 1000, Инструкция по эксплуатации, Страница: 6 / 8

MULTISTATION 1000
UPS 1000VA
Ver.00 12 Maggio 2016
6
3.5 Switch ON and switch OFF
To turn On the UPS press the switch ON/OFF (1), to turn Off the UPS press again the switch ON/OFF (1).
3.6 Cold Start
UPS is able to operate a cold start. To swith On the UPS when the electrical network is not present, simply
press the ON/OFF switch (1).
4
– TROUBLESHOOTING
STATUS PROBLEM RESOLUTION
All LEDs are Off

Discharged Battery

Recharge the battery for at least 8hr

Battery failed

Replace the battery with the same
type of product

On/Off button is not switched On

Push ON/OFF button on front panel
Continuous beep when Mains is
present
Overload on UPS
Verify that load doesn’t exceed the
rating of the UPS
Battery autonomy time in back-up
mode is short

Overload on UPS

Partially remove the load

Battery voltage is very low

Recharge the battery for at least 8hr

Battery failure due to high ambient
temperature or improper operation of
the battery

Replace the battery with the same
type of product
Battery mode yellow LED is On
but Mains is present

Power cord is not connected

Check that power cord is correctly
plugged in.

Input fuse is blown
Check the fuse and replace it, if
broken
Battery is not recharged Input fuse is blown
Check the fuse and replace it, if
broken
NOTE: If there are other conditions not listed, then contact our service center.