© Ernst Nagel GmbH 2S Trimmer Installation Manual en.doc Rev.1.0. 16.11.2010
19
7.
Thickness detection
NVM ‘Stop if booklet too thick’ is a value to set a warning for the Operator when a booklet is to thick to trim.
There are 3 different warnings adjustable, which are:
Value
1
Value
2
Value
3
Booklet too thick! not trimmed
Booklet too thick (STR003)
Booklet too thick (STR108)
(NO STOP: only message in
(SOFT STOP: booklet
(HARD STOP: booklet still
UI
display) transported
outside
the machine)
inside the machine)
Fig.
1 Fig.
2 Fig.
3
Change Operator Warning
Fig. 4
Fig. 5
Fig. 6
No. Action
1
Enter the Service Program mode
2
Use the ‘
▲
/
▼
’ buttons to select ‘NVM’ and press the ‘Enter’ button.
3
Use the ‘
▲
/
▼
’ buttons to select NVM 6 Stop if booklet too thick and press the ‘Change’ button.
4
Use the ‘
+ / -
‘ buttons to set a NewValue(Dec) 1, 2 or 3 (See options above) and press the ‘OK’
button.
5
Press the ‘ESC’ or ‘
’ button to exit the Service Program mode and enter the Operator mode.
NOTE: Install one of the Values, which is suitable to Operator requirements.
