85
9-7-3. Device
Select
Device
to set Alarm Out, Controller and PTZ, SPOT Out, Motion zone
ALARM OUT:
Set the Alarm Output Connector.
o
ALARM DURATION:
Set alarm dwell time from 5 to 60 seconds or infinite.
CONTROLLER:
Set the controller baud rate and ID.
PTZ:
Set the PTZ baud rate, protocol, and ID.
SPOT OUT:
Spot Out 1: from 1 channel to 16channel
o
SPOT ON EVENT:
Enable/Disable display of the channel when an event is active.
o
SPOT EVENT DWELL TIME:
Set the dwell time for the display of the event activated channel.
o
SEQUENCE:
Enable/disable sequential display of spot channel in full screen
o
SEQUENCE DWELL TIME:
Set the dwell time for the spot channel display
o
SPOT CHANNEL:
Select a channel for spot monitoring
MOTION:
Setup the motion detection area and the sensitivity.
o
CHANNEL:
Select the channel
o
MOTION ZONE:
FULL Zone or PARTIAL Zone
o
MOTION SENSITIVITY:
1~9 (High sensitivity level)
KEYTONE
: Sets On or Off of Key Tone.
REMOTE CONTROLLER ID
: Sets an ID number of which remote control to receive commands.
SENSOR:
Select the type of sensor.
