ENGLISH
10
18 POWER
•
Supplies the AC mains power to the M33.
•
When the POWER switch is set to ON position, the M33 goes to
standby mode as shown by the amber status condition of STATUS
INDICATOR (NAD logo) indicator.
•
Press
o
(Standby) button or HTRM 2’s remote control’s [ON] button
to switch ON the M33 from standby mode.
•
If you do not intend to use the M33 for long periods of time (such
as when on vacation), switch off the POWER switch.
•
With POWER switched off, neither the front panel Standby button
nor HTRM 2 remote control’s [ON] button can activate the M33.
19 FUSE HOLDER
•
Only qualified NAD service technicians can have access to this fuse
holder. Opening this fuse holder may cause damage thus voiding
the warranty of your M33.
20 GROUND TERMINAL
•
Ensure that the M33 is plugged-in to a grounded AC wall outlet.
•
If necessary, use this ground terminal to connect to ground a
phono or turntable source for PHONO input.
•
If a separate earth ground is necessary, use this terminal to ground
your M33. The M33 can be connected to ground by connecting a
ground lead wire or similar to this terminal. After insertion, tighten
the terminal to secure the lead.
21 AC MAINS INPUT
•
The M33 comes supplied with two separate mains power cords.
Select the mains power cord appropriate for your region.
•
Before connecting the power cord’s plug to the mains power outlet,
ensure that the other end of the power cord is firmly connected to
M33’s AC Mains input socket.
•
Always unplug the power cord from the mains power outlet before
disconnecting the other end of the power cord from M33’s AC
Mains input socket.
IDENTIFICATION OF CONTROLS
REAR PANEL