GB
11
AUDIO OPERATIONS
BASIC OPERATIONS
1
Press the POWER button to ON.
2
Adjust the tone as required with the BASS and TREBLE tone controls. Adjust the balance between the
left and right channels with the BALANCE control.
3
Select the desired source with the Source Selector. An indicator for the selected source lights up.
4
Select the desired surround mode with the SURROUND MODE buttons. (The SURROUND indicator
lights in the display.)
• Refer to available surround modes. (page 12).
• Refer to OSD surround mode. (page 16-17).
5
Start playing the source component.
6
Gradually turn up the volume to the required level with the MASTER VOLUME control.
1 POWER STANDBY/ON Button
Press this button to turn the power on. Press it again to turn the
system off (power standby mode). The STANDBY indicator lights up in power standby mode and goes
out when this unit is turned on.
2 BASS/TREBLE Tone Controls
These two tone controls - BASS and TREBLE - can be used to obtain a
“flat” frequency response or a tone which suits your individual listening preference. The Bass control
adjusts low frequencies and the TREBLE control adjusts the high frequencies.
3 BALANCE Control
This control is used to adjust the balance between the left and right channels.
Normally set to the center position.
4 MASTER VOLUME Control
Adjust the overall sound volume from the front, center, sub woofer and
rear speakers with this control.
5 FM MUTE/MONO
This button combines two functions, it switches the tuner from stereo to mono and
disengages the mute circuitry at the same time. The muting circuit will mute the Tuner in between radio
stations when searching or tuning. If FM broadcasts with weak signal strength are received, the FM
muting function works automatically to cut the signals, eliminating loud noise.
6 SURROUND MODE Button
Surround mode changes follows whenever you press this button.
• Refer to available surround modes. (page 12)
• Refer to OSD surround mode. (page 16-17)
NOTE
• You can not select DTS/DOLBY DIGITAL mode in Analog mode or except DVD, AUX Function.
• To select DTS/DOLBY DIGITAL mode, you should select optical or coaxial mode by DISPLAY button.
7 DISPLAY Button
Press this button to switch the digital signal when DVD, AUX selected. Refer to OSD
digital input (page 16).
When DVD selected
When AUX selected
CAUTION
In tuner function, this button toggles the display to show the PS/RT.
2
2
3
1
6
4
2
3
4
1
7
6
5
AUDIO ADJUSTMENTS
Optical
Coaxial
Analog
Optical
Analog
