Rev. 8-29-17
Part #C-00170
www.NabcoEntrances.com
GT20 Swing Door Owners Manual
3 of 10
Service Availability
Door products are distributed through a nationwide network of authorized suppliers for sales, installation, and service.
Immediately contact the Door Manufacturer or the Authorized Door Manufacturer Representative, if service must be performed
on an automatic door system.
SECTION 4.3: Safety Standard Compliance
The automatic door system was designed to comply with the latest operating and safety standards. To ensure continued, safe
operation it is important that:
X
The door system is maintained in compliance with industry standards.
X
Proper decals/labels are applied and maintained on doors.
X
All doors should be checked by an AAADM certified inspector at least annually.
The American Association of Automatic Door Manufacturers, has established a program to certify automatic door inspectors.
Through this program, inspectors are trained to check door systems for compliance with the appropriate version of an ANSI
standard. In the United States, ANSI Standard 156.10 (Used to cover Full Automatic doors) applies, and ANSI Standard 156.19
(Used to cover Low Energy doors) applies.
SECTION 4.4: Limited Warranty
NABCO Entrances Inc., for its Gyro-Tech product line, provides to its purchasing distributor a limited warranty on the equipment
supplied by NABCO Entrances Inc. The warranty is:
NABCO ENTRANCES INC. will exchange or repair, F.O.B. the plant, any component found
defective in workmanship and/or material, subject to NABCO’s inspection, for a period of one
(1) year after installation or 18 months after manufacture, whichever comes first. Warranty
does not include field service labor. The installing contractor/customer will be responsible
for installation and field service. This is NABCO ENTRANCES Inc.’s sole warranty.
This warranty does not cover loss or damages resulting from causes beyond the manufacturer’s control, misuse, neglect,
accidents, windstorms, or other acts of God, or acts of terrorism. Warranty is for normal use and service. The warranty does not
apply to equipment that has been repaired or altered so as to adversely affect conditions of operation. Warranty will not obligate
NABCO for damages resulting from such alterations, misuse, or acts of God, or acts of terrorism.
SECTION 4.5: Information Provided by Door Supplier
Note: To obtain an AAADM Daily Safety Check video, please go to http://www.aaadm.com/doorowners.asp
The Door Supplier must provide the Owner/Caretaker:
X
Instruction on how to conduct the Daily Safety Check.
X
Location of activation Switches and Push Plates with instruction of their use.
X
Contact number to call for Service.
X
Contact number to call for inquiries about the door system, and/or to report concerns.
X
An AAADM inspection form, or a Work Order signed by an AAADM certified inspector.
X
Affixed to the Door, a completed Annual Compliance Inspection label, at the bottom of the Safety Information label.
X
Warranty information for each Product.
CHAPTER 5: GENERAL SAFETY
Pay attention to the following safety items and perform checks periodically where noted.
X
Force (Force can be measured with a force gauge):
• Force to prevent the door from closing should not exceed 30 pounds.
• If the door is equipped, force to Breakout the door should not exceed 50 pounds.
• Force to open door in the event of a power failure should not exceed 30 pounds.
X
Breakout Mode (If Equipped): When the door (or door including a sidelite) is pushed into Breakout mode, check that the
door will not activate into other direction.
X
Strike Stile: With door open, grasp the Strike Stile of door and attempt to move it vertically and horizontally. There
should be very little, if any, looseness in the door pivots, and/or in connections between door and operator.