(Revised 2013-23-10)
Page 25 of 62
Extra Info
Extra Info
: displays the current device usage statistics and status of the system components in a pop-up
window.
Show Stations
: selection lists the stations which are connected to the device while operating in
Access Point mode.
Statistics for all stations (
RSSI
,
Tx Rate
,
Rx Rate
and
Idle
time) can be updated using the
Reload
button.
More statistics (
Station Uptime
,
Negotiated Rates
,
Static
WDS Flag,
Tx/Rx Frames
,
Tx/Rx
Bytes
) can be retrieved while clicking on the “
+
” button near MAC address of the each Station
entry.
RSSI -
Received Signal Strength Indication
(
RSSI
) is a measurement of the
power
present in a
received
radio
signal
.
Show ARP Table
: selection lists all entries of the ARP (Address Resolution Protocol) table
currently recorded on the device.
The list can be updated using the
Reload
button.
ARP is used to associate each IP address to the unique hardware address (MAC) of the devices. It is
important to have unique IP addresses for each MAC or there will be ambiguous routes in the
network.
Show Throughput
selection continuously represents the current data traffic on the LAN and WLAN
interfaces in both graphical and numerical form.
The statistics is updated automatically and can be updated using the
Reload
button.
Show Log
selection displays system log information
Show Bridge Table
: selection lists all entries in the system bridge table, while the device is
operating in
Bridge
mode.
The list can be updated using the
Reload
button.
Bridge table shows to which
bridge
port the particular station is associated to - in other words from
which
interface
(Ethernet or wireless ) the network device (defined by
MAC address
) is reachable to
the N-Tron 702-W system while forwarding the packets to that port only (thus saving a lot of
redundant copies and transmits).
Aging timer
shows aging time for each address entry (in seconds) - after particular time out, not
having seen a packet coming from a certain address, the bridge will delete that address from the
Bridge Table.
Show Routes
: selection lists all of the entries in the system routing table, while the device is
operating in Router mode.
