(Revised 2010-11-15)
9
APPLYING POWER (Top View)
Unscrew & Remove the DC Voltage Output Plug from the top header.
Install the DC Power Cables of the device to be powered into the Plug (observing polarity on unit).
Plug the Voltage Output Plug back into the top header.
Tightening torque for the terminal block power plug is
0.5 Nm/0.368 Pound Foot
.
Insert a CAT5e cable connected to a PoE Source device into the POE IN port.
Verify the Power LED stays ON (GREEN).
Note:
Either V
1
or V
2
can be connected to power for minimal operation. For redundant power
operation, V
1
and V
2
plugs must be connected with separate DC Power Cables. Use wire sizes of 16-28
gauge. The power cord should be limited to less than 10 meters in order to ensure optimum
performance.
Recommended PoE Power Source Equipment, similar to:
N-Tron 105TX-POE, 4 End Span PoE Ports (48VDC on Data Pair)
N-Tron 105FX-POE, 4 End Span PoE Ports (48VDC on Data Pair)
N-Tron 100-POE4, 4Mid Span PoE Ports (48VDC on Spare Pairs)