BX4 PLUS
21
11.
AUDIO DEVICES WITH CABLE CONNECTION
N-Com BX4 PLUS allows connection via cable (sold separately) to audio sources equipped
with the 3.5mm output generally used by these devices for the headsets.
To listen to the audio source, connect the cable to the helmet using the micro-USB port,
then start playing the audio file on the device, then activate the audio peripheral device
using the specific key.
Once it is turned on, cable connection stays active even in the subsequent menus.
Consequently, you can hear the device connected via cable even while listening to music
via A2DP or via RADIO.
12.
N-COM RIDER-PASSENGER INTERCOM MODE
In order to use
BX4 PLUS
in wireless intercom mode, both helmets have to be equipped
with a Bluetooth kit.
In order for two
BX4 PLUS
to communicate with one another, they have to be paired up
first.
12.1.
Intercom affiliation
1.
Make sure both N-Com Bluetooth systems are turned off;
2.
Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more than
4 seconds), until the LEDS start to flash quickly;
3.
On either one of the two helmets, press “on” briefly;
4.
After a few seconds, the helmets “recognize” each another, a beep is emitted to signal
the pair up was successful and intercom communication is activated;
5.
Turn off both N-Com Bluetooth systems and turn them back on to store the pair up
data.
12.2.
Intercom function
After carrying out the proper pair up procedure, turn on the two helmets. Intercom
connection will be established automatically (this will take a few seconds. Wait until you
hear the vocal confirmation message).
If automatic connection is not possible, proceed with the manual connection.
Manual intercom activation
With
BX4 PLUS
turned on, briefly press “on”.
Manual intercom
deactivation
With
BX4 PLUS
turned on, briefly press “on”.
