N-Com basic kit multi, Инструкция по эксплуатации

Страница: 13 / 36

13
Fig. 11
Fig 12
 Simulate positioning the microphone in order to determine where to apply the support Velcro. After installing
the microphone, its sponge must be positioned in front of the mouth.
N.B.: In case is not possible to insert the microphone into the shell you might install it out of it as shown in
Fig. 1 for Jet helmets.

Thoroughly clean the surface where the microphone Velcro will be applied.
 Apply the microphone Velcro to the helmet shell and allow it to fully adhere for at least 12 hours (Fig. 11).
 Apply the microphone making it stick to the Velcro (Fig. 12).
CAUTION : After installing the microphone, make sure the white dot and the writing “N-com” on the
microphone face the mouth (Fig. 12). When using the microphone, keep it near your mouth.