STORM-6, STORM-8 18 Rev.01-2021
TECHNICAL DATA
FREQUENCY BAND
CHAPTER 3: OPERATOR GUIDE
Do not perform this action when the receiver is in a session with another
transmitter. The radio communication may be
interrupted or broken.
NOTE! Only keep the transmitters that you intend to use registered in the receivers.
NOTE! To establish a radio link between the transmitter and the receiver, both units must be set to the same radio mode.
1. Press the receiver Function button. The function LED lights (red).
2. Press the receiver Select button. The relay LEDs light (red).
3. Press buttons 1 and 2. Keep pressed. The relay LEDs light (red). The relay LEDs flash (red) 2 times.
4. Release buttons 1 and 2. The relay LEDs flash (red) 1 time.
The transmitter is registered.
If no transmitter is found within approximately 10 seconds, the receiver exits to normal operation.
START THE TRANSMITTER
1. Start the transmitter by pressing any button on the transmitter.
