STORM-6, STORM-8 16 Rev.01-2021
CHAPTER 2: INFORMATIONS
Read all instructions and warnings carefully before mounting, installing and configuring the products.
These instructions have been published by Mz Electronic and are not subject to any guarantee. The instructions may be withdrawn
or revised by Mz Electronic at any time and without further notice.
Corrections and additions will be added to the latest version of the instructions.
IMPORTANT! These instructions are intended for installers. The instructions containing information about the installation and
configuration of the radio remotecontrol unit on the machine are not intended to be passed on to the end user
. Only
information
that is needed to operate the machine correctly by radio remote control may be passed on
to the end user.
Mz Electronic remote controls are often built into wider applications. Always refer to the applicable local regulations for
installation and safety requirements relating to cranes, hoists or other material handling and/or lifting equipments using Mz
Electronic products, e.g.:
◼
applicable local and industrial standards and requirements,
◼
applicable occupational health and safety regulations,
◼
applicable safety rules and procedures for the factory where the equipment is being used,
◼
user and safety manuals or instructions of the manufacturer of the equipment where Mz Electronic remote control systems
are installed. Mz Electronic instructions do not include or address the specific instructions and safety warnings of the end product
manufacturer.
Carefully read through the following safety instructions before proceeding with the installation, configuration, operation or
maintenance of the product. Failure to follow these warnings could result in serious injury and property damage.
Installing, connecting and mounting
•
This radio system must not be used in areas where there is a risk of explosion.
•
Mz Electronic remote controls are often built into wider applications. Those systems should be equipped with:
•
a wired emergency stop where necessary.
•
a brake.
•
an audible or visual warning signal.
•
Always switch off all electrical power from the equipment before installation procedure.
•
Only licensed or qualified personnel should be permitted to install the product.
•
The receiver should be installed well away from wind, damp and water. It must be securely attached and located where
it will not be hit by e.g. any moving parts.
•
To utilize the safety of the system, use the stop relays in the safety circuitry of the object that you want to control.
•
When the equipment controlled by the receiver's standard relays is connected via the stop relays, make sure that the
maximum current through the stop relays is still within the specifications.
•
Avoid registering transmitters in receivers where they are not being used
Operation
Only qualified personnel should be permitted to access the transmitter and operate the equipment.
•
Make sure that the user satisfies the age requirements in your country for operating the equipment.
•
Make sure that the user is not under the influence of drugs, alcohol and medications.
•
Make sure that the user knows and follows operating and maintenance instructions as well as all applicable safety
procedures and requirements.
•
The user should:
•
always test the transmitter stop button before operating it. Press the stop button then twist and pull it out. This test
should be done on each shift, without a load.
•
never use a transmitter if the stop button is mechanically damaged. Contact your supervisor/representative for service
immediately.
•
never let the transmitter unattended
always switch the transmitter off when not in use. Store in a safe place.
•
keep a clear view of the work area at all times.
Maintenance
ENGLISH
