MYSTIC Circuits IDUM, Руководство пользователя

Страница: 32 / 38

IDUM Official Manual
32
SETUP MENU
I
DUM has some extra options under the hood that can be accessed through the MENU. In
this mode, the active settings for each mode are displayed on the MODE ring of LED’s and
LOOP LED. These settings are saved when you exit the MENU and will save over power
cycles. To enter or exit the MENU, long press on the REMOVE MODE button to change
the menu options. Then, point the MODE knob at the option you would like to change.
Then short press on the REMOVE MODE button. It is important to unplug any modulation
from the mode CV input because this will influence where IDUM's processor will think the
mode dial is pointed. The names of each option are faintly written on the panel.
REMOVE MODE
Long Press to activate Set Up. LED’s will show current configuration.
Turn ‘MODE’ to point to the desired option then tap ‘REMOVE MODE’ to select
CYCLE SWITCH
In Set Up Mode the ‘CYCLE” Switch will allow setting the sequencer from 8
steps to 16 steps. This is not implemented in version 1.0 of the firmware.