04
HI-LINE RC & HI-LINE RC Heater/Cooler
5.0 Preparation
6.0 Fixing
l
Using the fixing dimensions below (see fig. 1), mark the fixing
hole positions on the wall.
l
Plastic or metal anchors suitable for No. 8 wood screws
should be used for mounting the convector to the wall.
l
Remove the backing from the self-adhesive washers and place
on screws with adhesive side towards the point.
l
Tighten the screws into the wall leaving about
3
/
8
"
projecting.
l
Press adhesive washers to the wall.
Remove the outer casing as follows:
l
Remove the 2 screws at each end of the outlet grille (see fig. 2).
l
Lift off the outer case.
l
Fit chassis on to mounting screws and tighten.
Note:
Before proceeding with pipe-work connections check that
the unit is level. If the right hand end is lower than the left then
the ability to vent the unit may be restricted.
When water connections and electrical connections have been
completed and the unit has been vented, fit the outer cover and
secure with fixing screws.
Unit
A
B
Dimensions (inches)
20-14
46
3
/
32
40
7
/
8
15-10
34
15
/
16
29
11
/
16
10-6
26
7
/
8
21
21
/
32
7-4
21
13
/
16
16
5
/
8
A
2
1
/
2
B
1
5
/
8
2
7
/
8
3
11
/
16
1
15
/
16
10
7
/
8
Fig. 1
Fig. 2 Case fixing screw positions
Before proceeding with the installation, unpack the carton
contents and check against the checklist below:
1.
HI-LINE RC fan convector.
2.
1
/
2
inch isolating valves (1 pair).
3.
Instruction manual.
4.
Fixing kit (rubber mounts and cable gland).
5.
Remote control handset.
24392 HiLine manual_Layout 1 22/12/2011 11:07 Page 5
