Myron Mixon Smokers 47101, Инструкция по сборке и эксплуатации

Страница: 16 / 20

16
Myron Mixon Pitmaster Q3 www.pitmasterQ3.com | 1-877-575-3173
TROUBLESHOOTING (cont.)
If the auger drive motor is not working, but the draft inducer fan is working, the problem is the auger system, which needs to be
checked:
• Turn the power switch to OFF.
• Locate the small fan blade on the back of the auger motor drive.
• Turn the power switch to ON and watch to make sure the fan blade turns. if it doesn’t turn it needs to be replaced. If it turns a bit and
then stops, turn the power switch to OFF and see if it unwinds slightly, indicating a jam that needs to be cleared. See the section
below for how to clear auger jams.
The Auger Jams:
If foreign objects or wet pellets jam the auger system, it needs to be removed and cleared: Making sure the power switch is OFF and
the power cord is disconnected, remove any covers necessary to access the auger drive motor.
Remove the screw connecting the auger drive motor shaft to the auger shaft and the screw retaining the auger bushing into the auger
tube. With a small pipe wrench or locking pliers on the auger shaft, turn the auger counter clockwise. It will turn hard until it breaks free.
Remove the auger and clean all pellets, ash or foreign objects from the auger, auger tube and firebox. A shop-vac will help. Sand the
outside surfaces of the auger with medium grit sandpaper. Sand the inside of the auger tube, if necessary. Vacuum sanding grit out of
the auger tube and firebox when finished. Reinstall the auger bushing and the auger into the auger tube, making sure the auger rotates
freely. Re-attach the auger shaft to the auger drive motor shaft.
The grill doesn’t fire on smoke setting:
This procedure to clean excess ash from the firebox: Open the door and remove the cast iron grates, grease drain pan and heat baffle.
Remove all unburned pellets and ash from the firebox. A shop-vac will help. MAKE SURE THE GRILL IS COLD AS HOT ASH CAN
CAUSE A FIRE.
Put the cast iron grates, grease drain pan and heat baffle back in position and follow the INITIAL FIRING INSTRUCTIONS.
How to change the Fuse:
There will be an extra fuse zip tied to the fuse cylinder is found on the back side of the control panel. Remove the screws holding the
control panel in place. On the back side of the control panel will be the fuse location.
If you are missing or require parts or need service help, please email info@pitmasterQ3.com
or call our customer service department at 1-877-575-3173 (Monday – Friday, 8:00 am – 5:00 pm, CST)
Extra fuse zip tied
to fuse cylinder
Remove old fuse from cylinder
and place the new fuse inside
the cylinder