Myron Mixon Smokers 47101, Инструкция по сборке и эксплуатации

Страница: 10 / 20

10
Myron Mixon Pitmaster Q3 www.pitmasterQ3.com | 1-877-575-3173
Parts required:
2 x Casters (8)
2 x Wheels (9)
2 x Wheel Caps (20)
Hardware required:
2 x Wheel axles (35)
2 x Axle washers (37)
2 x Axle pins (41)
Tools required:
Open end wrench (42)
Before mounting, note that one end of the axle holder in the
centre of each wheel is longer than the other. With the long
end of the axle holder towards the inside, insert a wheel
axle (35) through each wheel (9) and wheel leg (6/7). Put an
axle washer (37) on the other side, then insert the axle pin
(41) through the hole in the wheel and wheel axle. Apply the
wheels caps.
Turn over the assembled legs/bottom shelf, then use the
provided open end wrench to mount a caster (8) on each
caster leg (4/5) by clockwise turning the hex nut on the
caster into the threaded hole at the bottom of the leg tube.
STEP 4 Attach the Wheels and Casters to the Legs
ASSEMBLY INSTRUCTIONS
Parts required:
2 x Side bars (11)
Hardware required:
8 x Screws 1/4” (34)
Align the four holes in each side bar (11) with the holes near the
top of each leg assembly.
Insert a 1/4” screw (34) through each hole in the side bar, then
through the corresponding hole in the leg assembly. Tighten
screws. Also, tighten screws installed in Step 2.
STEP 3 Attach the Side Bars to the Legs
Screw
Side bar
Caster leg
Caster
Wheel leg
Axle pin
Axle
washer
Long end
of axle holder
Wheel axle
Wheel
Wheel cap