8 |
| 9
INSTRUCTION
MANUAL FOR MODELS
Warning:
Be sure to keep a distance around the heater of at least 30cm (300mm) see image
above.
Warning! When drilling holes, always check to ensure there is no electrical wiring,
gas pipes, water pipes etc in the area to be drilled.
| CONTROL PANEL AND SCREEN
Unit is in heat mode
Power button: on /stand by
Setting / OK button
Open-window on/off button
Increase button: press to
increase temperature. Also used
for setting forward the hour in 24
hour program setting
Decrease button: press to
decrease temperature. Also used
for decreasing the hour in 24
hour program setting
Mode selection
| SCREEN LOCK
If the unit controls are not used for more than a minute the controls will automatically
lock as a child safety function. To unlock, simply press
and
at the same time.
| OPERATION
Basic Operation:
Press the power button
to turn on the screen, the heater will work under COMFORT
mode, press
to set your desired temperature. Press
to choose the mode
or the program
;
•
Comfort mode: Temperature can be set from 5°C to 35°C.
•
ECO mode: Temperature can be set from 1.5°C to 31.5°C, which is 3.5°C less
than comfort mode.
•
Anti-frost mode: Setting 7°C for room temp, this temperature cannot be adjusted
and is a preferred mode for garages, caravans etc.
Clock setting:
Before setting programs P1/P2/P3, the clock will require setting.
Press
for 3-4 seconds, the hour setting will flash, press
/
to set to the
current hour (0-23), once hour is selected press
and the minute setting will flash,
press
/
to set to the current minute (0-59), once current minute is selected
press
and the day setting will flash, press
/
to set the current day from 1-7
(Mon-Sunday), once current day is selected press
to confirm your settings.
Please Note:
if the unit is unplugged or power is switched off from its power source the
unit clock may need to be reset when switched back on.
Program Settings P1, P2 & P3:
Before setting any Program, it is ideal to pre-set the heat mode temperature to your
desired temperature. Press
until one of the heat modes
Comfort mode,
ECO mode or
Anti-frost show and choose your temperature by using the
or
symbol, once set press
to move onto the next heat mode and repeat,
remember the Anti-frost is preset and cannot be changed. These set temperatures
will now show in your programs as you set them. You can also manually change the
temperature at any point whilst the program is in operation by simply pressing the
or
symbol.
Program P1
is preset for days 1-7 (Monday – Sunday), but the hour and heat mode can
be adjusted to your requirements, the program repeats your set time and heat mode
Monday-Sunday (1-7). This program is ideal to set if you want the time and heat to
operate at the same time every day.
Below is an example of P1 set for Days 1-7 (Monday – Sunday). You can set your own
hours and heat modes for these set days.