4 |
| 5
INSTRUCTION
MANUAL FOR MODELS
and clean the appliance or perform user maintenance.
• CAUTION - Some parts of this product can become very
hot and cause burns. Particular attention has to be given
where children and vulnerable people are present.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• CAUTION: In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not
be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
• The heater must not be located immediately below a
socket-outlet.
• Means for disconnection having a contact separation
in all poles must be incorporated in the fixed wiring in
accordance with the wiring rules.
• For correct installation on the wall, thanks to refer to
‘Installation on wall’ part.
• Fixed heaters are to be installed so that switches and
other controls cannot be touched by a person in the bath
or shower.
• WARNING:
The heater must not be used if the glass
panels are damaged.
•
WARNING:
In order to avoid overheating, do
not cover the heater.
WARNING:
This product can only be fitted in Zone 2 and
above in a bathroom according the national wiring rules.
Note: The drawing below is for reference only. If fitted in
a bathroom it should be fitted by a qualified electrician. In
the case as of buildings room, a room receiving a bath or a
shower and socket-outlets lower or equal to 32 A the circuit
corresponding must be protected by a device with differential
residual current (RCD) lower or equal to 30 mA
225 cm
60 cm
240 cm
Zone 1
Area under bathtub
Zone 0
Zone 2
Zone 3
Out of zones
Floor
THIS PRODUCT IS FOR ROOM HEATING
FOR HOUSEHOLD USE ONLY