MYIRO myiro-9, Инструкция по эксплуатации

Страница: 34 / 44

Troubleshooting
▍
Error messages
The messages below may be displayed when using the instrument. When one of these messages appears, please take the action indicated
below. If the message continues to appear even after taking the recommended action, contact your retailer.
Error message Possible cause/problem Action
Paper jammed Paper has jammed in the MYIRO-9. Follow the procedure below to clear the paper jam.
Paper has jammed in the Auto Sheet Feeder. Follow the procedure on p. 32 to clear the paper jam.
Cover opened Cover of MYIRO-9 is open. Close the cover and wait until MYIRO-9 initialization is complete.
Fatal Error
Error code: ********
Warning code: ******** A fatal error has occurred. Switch off the MYIRO-9, wait 30 seconds, and then switch it back
on. If the error continues to occur, note the Error code and
Warning code numbers, and contact
your retailer.
▍
Clearing paper jams
If the paper becomes jammed during measurement, follow the procedures below to remove the jammed paper.
When using MYIRO-9 without Auto Sheet Feeder
When using the MYIRO-9 without the Auto Sheet Feeder, the location of paper jams is usually where the paper is fed between the base and
the scan mechanism.
1
Press to eject the paper. If the paper cannot be ejected by
the MYIRO-9, continue with the steps below to manually clear
the paper jam.
2
Switch off the MYIRO-9.
3
Disconnect all cables (USB cable, LAN cable, AC adapter cable).
4
Open the cover.
5
Loosen the two screws as shown completely so that they are
free of the base.
6
Close the cover.
7
Grasp the ends of the MYIRO-9 and tilt the MYIRO-9 body
backward as shown. The base should stay flat.
8
Remove the jammed paper.
32