Fig. 5
Fig. 4
Fig. 6a
Fig. 6
25mm
Fig. 7
4
5
3.5 INSTALLATION OF THE GEAR MOTOR
a) Lift up the motor cover.
b) Insert the four hexagon-headed screws with the washers and
nuts in the loops of the motor base (Fig. 4).
c) Route the electrical cables in the purpose fabricated hole of
the motor base (Fig. 5) and gently lower the motor base
onto the anchor plate.
d) Move the screws in the loop’s centre and screw them up till
the lower nut rests on the anchor plate.
e) Use a spirit-level to make sure that the gear motor is perfectly
level (Fig. 6), if it is not adjust the four screws accordingly.
Then tighten all nuts.
f) Release the gear motor for manual operation as illustrated in
section 6 of this manual.
3.6 ASSEMBLY THE RACK
3.6.1 INSTALLING THE TOOTHED RACK B117 -
PVC RACK M4 20X26MM WITH INNER STEEL
FRAME (0.5M SECTIONS)
a) Move the gate manually to its open position.
b) Align the first section of the rack to the gate edge and lower
it on the pinion. Use a spirit-level to make sure it is perfectly
straight.
c) Fix this first section of rack to the gate with the provided
self-tapping screws. Fix the screws in the in the middle of the
slot as illustrated (Fig. 7).
d) Close the gate manually for about ½ meter, join the second
section of rack to first one and place it on the motor drive
pinion cog.
ENGLISH
ENGLISH
