5
3.1.1 Treatment using Sapphire Light crystals, never worn, whole life without
replacement.
3.1.2 Powerful semiconductor cooling, air cooling and water cooling can ensure
longer condition working time. Water cycle & water temperature checking
system and strongly heat abstractor extend service life and safety of the
machine.
3.1.3 Short treatment time, regeneration fast, no effect for work.
3.2 Application
Hair removal: remove extra hair of body parts, such as the armpit hair, beard and lip
hair, hair, bikini line, limb body hair effectively. It also reduces pigmentation,
Telangiectasia, deep color of moles, spiders to the grain, wine red birthmarks and
other symptoms.
Chapter 4 Working Conditions
4.1 Environment temperature: 5
～
40
℃
4.2 Relative humidity: ≤80%
4.3 Power supply: a single phase AVC 220V
、
110V ± 10% 10A 50/60Hz.
The power supply connected to Laser must have a single phase three wires power
socket that meets international standards, connections for power.
4.4 The power should be well earthed in accordance with the electrical safety
regulations in force.
4.5 The machine adaptation voltage range is 200 - 240V/100--120V. If the used
power is beyond the range, voltage regulator, whose power is higher than 3KVA,
is suggested.
Chapter 5 Installation and debugging
Procedure for Injecting Cooling Water
Only use distilled water in this device, DO NOT use tap or bottled drinking water
Step 1:
Take off the screw cap of the Overflow Hole, place a bucket or bowl
underneath this outlet.
Step 2:
Connect soft end of water pipe to funnel
Step 3:
Remove plug and insert the hard end of water pipe into Immit Water Hole.
Step 4:
Carefully pour cooling water into the funnel - Lift the funnel higher than the
equipment in order to inject water easily.
Step 5:
When water comes out from the Overflow Hole, Which means the water
injection is finished and water tank in the equipment is full of water.
Step 6:
Push the blue plastic ring on the Immit Water Hole, and then take the water
pipe off.
Step 7:
Replace Overflow Hole screw cap. The water injection is finished.
