12
INSTALLATION, WIRING & PROGRAMMING GUIDE
REQUIRED PARTS FOR
CrimeStopper
INSTALLATION
MyCar Telematics device
HRN-MCAR-01
CrimeStopper
HRN-LLRS-01
STEP 1. CONFIGURE THE REMOTE STARTER
The CrimeStopper remote starter must be configured to accept the MyCar telematics device. When pro-
gramming the CrimeStopper remote starter,
please ensure to select the option indicated “Smart Phone
Baud Rate”. This option MUST BE SET TO 9600baud.
1- Disconnect the HRN-LLRS-01 white connector from Crimestopper Remote Starter
2- Go in the Crimestopper programming and set Baud rate to 9600.
3- Shut ignition Off and Disconnect Power from the Crimestopper RS.
5- Wait 10 seconds. Then Reconnect RS and the HRN-LLRS-01 harness for the MyCar.
STEP 2. CONNECT
(1)
Connect only when remote starter is not supplying power to telematics device
Compatible models:
RS00, RS1, RS3, RS4, RS5,
SP402,SP502
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+)
12V BATTERY
(1)
GROUND
(1)
+12V Ba
tt
ery
(RED
)
Gr
ound
(BLA
CK
)
Da
ta
(WHITE
)
Da
ta
(BL
UE
)
Alarm(+)
(YELL
O
W
)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation:
Horizontal; small door
facing upward (as seen in this diagram)
HRN-LLRS-01