MyBinding IDEAL 4850-95 EP, Инструкция по эксплуатации

Страница: 12 / 18

IDEAL 4850-95 EP; IDEAL 5221-95 EP; IDEAL 6550-95 EP
11
01-01-23 B5221G1A doc
4.2 Blade replacement
Despite correctly set cutting depth and new
cutting stick if it is not possible to achieve a
clean cut
Þ
sharpen or replace the blade.
Blade demounting
s
Danger!
The blade is very sharp. Do not dismount or
transport the blade without blade protection.
- Lower the knife by pressing both cut buttons.
Keep one button pressed and turn off the
main switch (5).
- The eccentrics (1) are now exposed and
should be turned to position 0 (special wrench
found in tool set).
- For model 4850 the knife screw (6) must be
removed.
- Remove the special wrench and turn on the
main switch (5) until the knife returns to the
home position.
- Remove the 2 knife screws (2).
- Put the knife changing tool (4) into place and
fasten it to the knife.
- Screw out the remaining 2 respectively 3
blade screw.
- Loosen the grips of the knife changing tool (4)
lightly.
- Take the knife downwards out of the
machine.
- Change the cutting stick as described above.
Blade mounting
- Place the knife to be exchanged with the knife
changing tool (4) mounted, into the knife
carrier (3) up to the top and screw it into place
with the grips.
- Lightly tighten 3 of the 5 knife screws (with
washers).
- remove the knife changing tool
- Lightly tighten the remaining knife screws
(with washers) (2).
- For model 4850 the knife screw (6) can only
be inserted after the knife has been lowered.
- Remove all tools and distribute paper along
the entire cutting length.
- Lower the knife by pressing both cut buttons.
Keep one button pressed and turn off the
main switch (5).
- The 3 eccentrics (1) should then be used to
lower the blade until the paper is cut along
the entire length of the knife (The knife must
remain parallel to the cutting stick).
- If needed, the knife can be lowered using the
knife depth adjustment screw (9) (Knife must
be in upper position).
- For model 4850 tighten the knife screw (6).
- Turn main switch (5) to position I.
- The knife will return to the upper position and
the knife screws should be tightened firmly.
- As described cut a stack of paper.
l
Warning!
Blades may only be sharpened by
specialists.