My Geko Gear ORBT 956, Быстрое руководство пользователя

Страница: 6 / 20

·
Do not remove the Micro-SD card while the camera is power on.
·
Otherwise it may cause Micro-SD card to be write protected and possible loss of
data or damage your memory card. Always remove/insert Micro-SD card while
camera is power off.
The rear camera equipped with a 6-meter cable is to connect to the dash-cam via
AV IN port. Please check if the provided cable is long enough to reach the rear
cam in your car. Please follow these steps for installation:
1. Connect the rear camera jack to the AV IN port of the dash cam. If connected
properly, front and rear camera video will be shown on the dash cam screen.
2. Place the rear camera on the rear windshield by using the adhesive stickers
provided.
Charging
·
Please use the supplied original charger to power and USB cable to charge dash
cam.
·
Do NOT Connect the camera to laptop for Charging
After inserting a SD card and powered on, press once to stop recording,
and press once to the video setting.
Resolution
Allow to choose the desired video resolution and fps(frames per second). Higher
resolution and FPS videos result in smoother videos, but also take more storage
space.
Default video resolution：Front 4K and Rear 1080P, FPS Stands for "Frames Per
Second." FPS is used to measure frame rate – the number of consecutive
full-screen images that are displayed each second.
myGEKOgear
Loop Recording — Off/ 1min/ 3mins(Default)/ 5mins
Allow to choose the desired video resolution and fps(frames per second). Higher
resolution and FPS videos result in smoother videos, but also take more storage
space.
Rear camera installation
MODE (VIDEO/PHOTO/PLAYBACK) SETTING
NOTICE
Inside the rear windshield