page 6
1. Lower the walker all the way down and place the walker on a flat level surface.
Place the seat unit into the centre of the baby walker.
2. Attach all plastic clips on the seat unit
to the walker body in the following order:
A. (See Fig 1) Starting with the seat unit’s
arm rests, insert clips through the holes (1)
and (2) in the seat unit fabric then insert
the clips into holes (A1) and (A2) on the
walker body.
B. Next, attach the seat unit’s backrest by
pushing the plastic clips into holes (B1),
(B2), (B3) and (B4). Start from one side
and work your way around. Grip the back
of the seat unit as low down as possible
(Fig 2), feeling for the head of the clip
and ensuring the clip is lined up with it’s
hole, push the clip in (Fig 2a).
Note: If a clip is not protruding from the
seat unit you may need to locate it and
pull it through the hole in the seat cover.
C. Finally insert the pins at the front of the
seat unit into keyhole slots (C1), (C2) and
(C3). (Fig 3)
WARNING: Ensure all pins and clips are
properly attached before placing your
child in the seat.
Fig 1
Fig 3
Fig 2a
Walker
body
Seat
fabric
Fig 2
1
2
C1 C2
C3
B1
B2
B3
B4
A2
A1
Fitting the seat unit
