My Audio Illunis Series, Руководство пользователя

Страница: 7 / 28

- ILLUNIS ACTIVE SERIES -
1. INTRODUCTION
Congratulations for having chosen the ILLUNIS Active series of loudspeaker system! To make the best use of the system,
please read this manual thoroughly before operating the equipment.
2. CONTENTS
3. Instructions for use and installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
4. The ILLUNIS ACTIVE series . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
5. Installation and connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
6. Connection panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
7. Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
3. INSTRUCTIONS FOR USE AND INSTALLATION
1. PROTECTION AND MAINTENANCE
To avoid jeopardizing correct operation, it is better not to put the enclosures for long periods in exposed places (damp,
high temperature, etc.), in dusty environments or those subject to strong vibrations.
On this subject, it’s advisable to always leave the protective grid mounted on the enclosures. In the
event of breakdown,
do not open the enclosure, but contact the nearest MY AUDIO Centre.
2. CONNECTIONS
Avoid installing your equipment next to radios, televisions, etc., since this could cause noisy disturbance. When connecting
other equipment to your sound system, pay close attention to the so-called earth loops, which can cause hum: in the
event of interference, try using the SHIELD switch on the enclosure’s control panel.
Before connecting the enclosure to the mains supply, make certain that the current corresponds with that indicated on the
rear of the unit (there is an allowance of ±10%). Always connect the power cable to the enclosure before switching on the
enclosure and always remove it after having switched off.
Remember to always connect or disconnect other equipment with the enclosure off and to always switch on the mixer
first, then the enclosure: in this manner, annoying and often dangerous peaks are avoided.
3. CONNECTOR CABLES ( FIG.2 )
When connecting the enclosures to the mixer, make certain to always use only screened signal cables made up of two
wires plus a braid/screen: the use of unscreened cables could in fact probably cause annoying hum and noise. Check
periodically that your cables are in good condition, correctly wired and with perfectly efficient contacts: in fact many
problems and drawbacks (false contacts, ground hum, crackles, etc.) are caused by the use of unsuitable or damaged
cables.
4. THE ILLUNIS ACTIVE SERIES ……………………….……… Fig. 2
The ILLUNIS Active series is a range of passive loudspeaker systems hosted in Polypropylene cabinets. The series includes
4 different models.
■
ILLU NIS 12A: it is fitted with a 1” compression driver horn and with a 12” woofer. The built-in power module includes one
250W RMS AB amplifier for the low section and one 50W RMS AB class amplifier for the high section.
■
ILLU NIS 10A: it is fitted with a 1” compression driver horn and with a 10” woofer. The built-in power module includes one
200W RMS AB amplifier for the low section and one 50W RMS AB class amplifier for the high section.
www.myaudio.it ILLUNIS ACTIVE