MX Options Sequential, Инструкция по монтажу

Страница: 8 / 16

CAUTION
Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water.
The use of a residual current device (RCD) is recommended.
!

!
!

!
10. FITTING THE MIXER VALVE
CONCEALED OPTION
IMPORTANT: Ensure that you have read through section 7. IMPORTANT INSTALLATION INFORMATION before
starting to fit the mixer valve.
1. The fitting of the mixer valve is essentially the same
as described for the exposed option, except that the
mixer valve is fixed to the wall between 60mm and
90mm below the finished surface of the shower. A
circular hole between 140mm and 155mm should
be enough to fit the mixer valve (Fig 1).
2. The supply pipework can be plumbed from above
or below but must finish at the suitable connections
which should be at 150mm centers. This pipe
work must have 3/4” BSP male connectors for
connection to the valve.
NOTE: You should measure the distance between the
outlets on the mixer valve you are fitting to determine
the exact distance.
3. Complete the fitting of the pipework and the tiling
leaving the pipework as shown (Fig 2).
4. Position the mixer valve onto the two water feed
pipes. Tighten up the nuts to hold the mixer valve in
place (Fig 3).
NOTE: Make sure the mixer valve outlet is pointing
down and the hot feed is onto the left side marked
with a red indicator.
5. A pipe must be fitted from the outlet of the mixer
valve to the location of where you wish to position
the wall outlet.
NOTE: The wall outlet is not supplied.
NOTE: Once the mixer valve and wall outlet are
fitted, prior to fitting the trim plate disc ensure all
connections are watertight. This can be done by
reconnecting the water supplies and checking the
connections when running the shower and when the
shower is off.
6. To fit the trim plate the control lever must be
removed. Firstly remove the blue and red cap to
expose the grub screw using allen key supplied.
Undo and remove the lever (Fig 4).
7. The trim plate disc is fitted by pushing it onto the
mixer valve until flush with the tiles (Fig 5).
8. Reasamble lever to valve (Fig 7).
NOTE: Sufficient space should be left behind the trim
plate disc to allow access to the elbows for servicing.
3
1
2
60mm
Minimum
4
6 5