MVP SPRINT, Руководство пользователя

Страница: 21 / 30

7
Your MVP | SPRINT driving slowly and won’t speed up?
Reason #1: The battery is low
While the MVP | SPRINT is on:
1. Open the flap
2. Check to see if the red LED is flashing slowly (low battery)
• If the low battery light is on:
3. Remove the MVP | SPRINT from the training session
4. Plug the MVP | SPRINT into the charger to avoid damaging the battery
(a full recharge may take up to 6 hours)
3. If the battery is not low check reason #2
4. For more information on the battery see page 8
Reason #2: The motors are overheating and are going into safe mode until it cools down
While the MVP | SPRINT is on:
1. Open the flap
2. Check to see if the red LED is flashing rapidly (overheating)
• If the overheating light is on:
4. Remove the MVP | SPRINT from the training session
5. Relocate the MVP | SPRINT to a cool location (indoors or in the shade)
6. Turn off the MVP | SPRINT & allow to cool down
Your MVP | SPRINT does not respond to commands from the remote controller.
Reason:
The controller is not on or is out of batteries. Replace the AA batteries in the bottom of the controller
Your MVP | SPRINT is driving in reverse or turning the wrong way?
Reason: The reverse toggle switch under the clear plastic on the side of the remote flipped to the opposite incorrect side:
Try switching it to the opposite side
Your MVP|SPRINT is turning very slowly?
Reason #1: The steering dual rate knob is not turned all the way clockwise:
Turn it all the way clockwise if it is not.
Reason #2: The foam ring on the steering wheel is loose or off track: Ensure the foam ring is fully secure and fitting properly
on the steering wheel. You may need to grip the steering wheel harder
Your MVP|SPRINT drifts when driving?
Reason #1: The Trim knobs are not in the correct position:
Ensure the trim knobs are centered
(If the trim knobs are centered and your MVP|SPRINT still drifts)
Reason #2: The calibration is off: Follow calibration procedure:
Calibration Procedure:
1. Lift the MVP|SPRINT wheels off the ground by placing it securely on an elevated object (4x4s work well)
2. Turn on the remote controller
3.
Push the “cal” button the MVP|SPRINT using a long, thin object. The LEDs will flash solid, then begin blinking
rapidly.
4. Move the steering wheel and the throttle trigger back and forth to their limits until the LEDs flash solid a second
time.
5. Do not touch the remote controller for several seconds until the LEDs flash for a third time
6. Calibration is now complete
(Overheating Alert)
Troubleshooting cont.