10
▪
The battery is expected to last between two (2) and five (5) hours depending upon the type,
frequency and duration of drills between charges.
▪
Once a battery
’
s charge has been completely used, it will need to be plugged into its charger. The
charger will recharge the battery in approximately six (6) hours.
▪
MVP | SPRINT will beep if left idle for five (5) minutes. This is a reminder to turn off your dummy
at the end of each session. You can silence the beep and restart the five-minute idle time by
turning the MVP | SPRINT in place.
▪
If MVP | SPRINT slows down it is at the end of its charge cycle and the battery is near empty. Use
the remaining battery charge to drive the unit to its charger.
▪
Turn off MVP | SPRINT when not in use to avoid serious damage to the battery and to avoid
wasting the current charge on the battery. If the MVP | SPRINT beeps due to being left idle, turn
off the MVP | SPRINT.
▪
To prolong battery longevity, see Battery Use, Storage, and Charging Instructions.
▪
Do not attempt to use the MVP | SPRINT more than 200 yards from the controller.
▪
If planning to store the MVP | SPRINT for more than seven days see Battery Use, Storage, and
Charging instructions.
General Operating Information
Содержание SPRINT
